LED floor displays
Four floor series.
One dedicated production line.
Every series here is a screen people walk on. What separates them is load rating, sealing grade and how much punishment the surface has to absorb.
1 000 kg/m² (205 lb/ft²)
AlumaPlate
Ultra-slim indoor LED floor at 50mm or 80mm cabinet height, weighing 32 kg/m² — 60% lighter than steel-frame floors. Built for raised access floors and load-sensitive subfloors in museums, control rooms and retail.
Full specification →
2 600+ kg/m² (533+ lb/ft²)
AnchorIron
High-load indoor LED floor rated 2 600+ kg/m², with embedded optical sensors for touchless interaction and reinforced steel cabinetry for 50 000+ hours of continuous heavy traffic.
Full specification →
2 600+ kg/m² (533+ lb/ft²) — car-proof stage
AlumTour
Die-cast aluminium rental LED floor rated IP66 and 2 600+ kg/m², with tool-free magnetic locking for 5-minute module swaps. Vibration-tested for 10 000 km road transport and 100 000+ rental cycles.
Full specification →
2 600 kg/m² (533 lb/ft²)
ArmorIron
Outdoor LED floor with German-imported PC armour rated IK10+, self-healing anti-scratch nano coating and distributed waterproof control pods that eliminate single-point signal failure.
Full specification →Selection matrix
Side by side.
| Specification | AlumaPlate | AnchorIron | AlumTour | ArmorIron |
|---|---|---|---|---|
| Load capacity | 1 000 kg/m² | 2 600+ kg/m² | 2 600+ kg/m² | 2 600 kg/m² |
| Ingress rating | IP54 | IP54 | IP66 | IP66 / IP68 |
| Environment | Indoor | Indoor | Indoor / outdoor touring | Outdoor |
| Surface armour | Matte anti-glare + scratch coating | Imported PC mask + nano coating | GOB or anti-scratch PC mask | German PC mask, IK10+, self-healing |
| Optical sensing | Yes | Yes — embedded grid | Yes — zero latency | Yes — sunlight-immune |
| Cabinet | Aluminium, 50 / 80 mm | Reinforced steel | Die-cast aluminium | Aluminium, 960 × 960 mm |
| Built for | Load-sensitive subfloors | Continuous crowd traffic | Repeat setup & road transport | Weather, impact, public squares |
Load ratings are cabinet specifications. Final structural design depends on subfloor condition and is confirmed per project.
Common questions
LED floor, answered.
What is an LED floor display?
An LED floor display is a walk-on LED screen built into the floor surface. Unlike a wall-mounted screen it must carry crowd loads, survive being walked on and dragged over, dissipate heat without venting upward, and — in AOE systems — sense foot position through embedded optical sensors.
How much weight can an LED floor take?
AOE AlumaPlate is rated 1 000 kg/m² for load-sensitive subfloors and raised access floors. AnchorIron, AlumTour and ArmorIron are rated 2 600+ kg/m² for crowds, touring stages and outdoor public areas.
Can an LED floor be used outdoors?
Yes — ArmorIron Outdoor Floor Series uses IP66/IP68 sealing, a German imported PC mask with IK10+ impact resistance and distributed waterproof control pods so a single flooded module cannot break the signal chain.
Are AOE LED floors interactive?
Yes. Optical sensors sit beneath the display surface and track foot position in real time, driving interactive content and crowd analytics without cameras or wearables.
Which AOE floor series should I choose?
Choose AlumaPlate for slim indoor installs on load-sensitive subfloors, AnchorIron for permanent high-traffic indoor venues, AlumTour for touring and rental use with tool-free module swaps, and ArmorIron for outdoor public installations.